Backflow Testing in Goldsboro, NC

What happens when you call

You'll be connected with an independent plumber who works in Goldsboro. Expect a few questions: Is this a new sprinkler or business connection, an existing device that needs a test, or a leak? Is the property on City of Goldsboro water, or outside the city on Wayne Water Districts or a well? Is there a letter or tag from the water provider? With that, the plumber can tell you whether it's a test, a repair or a new install, and what the provider is likely to want on paper.

Because we couldn't confirm Goldsboro's requirements, a careful plumber will check with the city before installing a device or filing results. That's a phone call worth making before parts are ordered.

What affects the cost

• Kind of job: testing an existing assembly is far less work than installing one
• Device type: a double check, pressure vacuum breaker or reduced pressure assembly, set by the hazard
• Pipe condition: older galvanized lines may need a section replaced to fit a new device
• Location: a device in a cramped crawl space or deep box takes longer
• Permit: new installs inside Goldsboro and its one-mile ETJ are permitted by the City Inspections Department, not Wayne County

Goldsboro conditions

Goldsboro runs its own treatment plant on Jordan Boulevard, drawing from the Neuse River with the Little River as a backup source. Past the city limits, unincorporated Wayne County is largely served by Wayne Water Districts, which relies on wells, so neighbors a mile apart may have different providers and different rules.

The housing stock leans older: about 59% of homes were built before 1980, and the median is 1975. Mid-century houses often have supply lines that were never planned with an irrigation tap in mind, so placing an assembly close to the meter, ahead of other branches, may take some pipe work. Businesses that serve the air base and the US 70 corridor, such as restaurants and car washes, are the kinds of connections where backflow protection usually matters most.

If your property has an old well that predates city service, it must never be tied into the city plumbing.

Before the plumber arrives

• Find your water bill and note the provider
• Locate the meter box and any brass assembly near it
• Pull out any notice or prior test report you have
• If water is spraying, close the irrigation valve or main shutoff
• Clear shrubs or mulch away from the device