Well Pump Repair in Angier, NC

Signs the well needs a plumber

• The house goes dry while the lights are still on
• The pump kicks on and off in short, rapid bursts
• A steady hum from the pump with no water coming through
• Pressure that slowly fades as the day goes on
• Air spurting from faucets, or water that suddenly turns gritty
• The pump's breaker trips again soon after you reset it

If the pump runs without stopping, switch it off at the breaker. A submersible motor running dry or pushing against a broken line can overheat in a short time.

Angier's water setup

Angier sits at the NC 55 and NC 210 crossroads in northern Harnett County, with a small piece of town in Wake. The town doesn't treat water; it buys it from Harnett Regional Water, whose plant in Lillington draws from the Cape Fear River, and distributes it to customers in town. If you get an Angier water bill, any pressure problem is in the plumbing, not in a pump you own.

Outside town limits the picture is mixed. Outlying 27501 homes may be on Harnett Regional Water lines or on private wells, and no address-by-address list exists. About 31% of Angier's homes were built before 1980, while much of the growth since 2000 has been newer subdivisions, so well systems around town range from decades old to nearly new.

What affects the cost

• The part at fault. A pressure switch, gauge or control box is a smaller job than a pump down the well.
• Well depth. The deeper the pump, the more drop pipe and wire to pull and reinstall.
• Pump type. Submersible pumps come up out of the casing; jet pumps sit above ground.
• Tank condition. A waterlogged tank is often replaced at the same time to protect the pump.
• Older systems. On a well that's been in service a long time, wire splices and check valves may be worth replacing while everything is exposed.

What to expect when you call

You'll be connected with an independent plumber who covers Angier. Tell them whether you're on town water, Harnett Regional Water or a private well, what the pressure gauge says and what the pump is doing. Building permits inside Angier go through the Town of Angier Planning and Inspections at Town Hall. For homes outside town, the plumber will confirm which office handles the permit, if one is needed.